Chapter 4.0 Arming the System
4.5.1 Arming the System with a 2-Way Wireless Key
If configured, the PowerSeries Neo system can be armed using the following wireless keys:
l
PG4929/PG8929/PG9929
l
PG4939/PG8939/PG9939
To Arm the System with a 2-way wireless key
l
Press the desired Arming mode button anytime the system Ready indicator is on.
4.5.2 Arming the System with a Proximity Tag
Depending on how your keypad is programmed, proximity tags can be used to either arm/disarm the
system or to perform a programmed function (e.g. unlock a cabinet or storeroom door).
To Arm the System with a Proximity tag
l
Present your Proximity tag to a keypad equipped with a proximity sensor anytime the sys-
tem Ready indicator is on.
l
If configured by your installer, enter your access code.
4.6 Disarming the System
Depending on your system configuration, there are multiple methods you can use to disarm your sys-
tem. You can disarm the system using a:
l
2-way wireless key
l
Proximity tag
To Disarm the System with a Keypad
1.
Enter your [access code] or present your proximity tag anytime the system is armed .
(Armed
indicator is on).
2.
If you walk through the entry door, the keypad will beep. Disarm within _____ seconds to
avoid an alarm condition.
To Disarm the System with a 2-way Wireless Key
1.
Press the disarm button anytime the system is armed. (Armed
indicator is on).
2.
If you walk through the entry door the keypad will beep. Press the disarm button within ____
seconds to avoid an alarm condition.
Note:
After disarming a system with an HS2LCD keypad using a 2-way wireless key, always
check the alarm memory to determine if any alarms have occurred during the armed period.
To Disarm the System with a Proximity Tag
1.
Present your proximity tag to a keypad equipped with a proximity sensor anytime the system
is armed . (Armed
indicator is on) and if configured as required, enter your access code.
2.
If you walk through the entry door the keypad will beep. Present your proximity tag within
_____ seconds to avoid an alarm condition.
Note:
Duration of Entry timer is programmed by installer. The installer will advise the maximum
duration of entry delay that was programmed in the system. It cannot exceed 45 seconds.
4.6.1 Disarming Error
If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this
occurs, press [#] and re-enter your access code.
- 11 -
