Nemtek Druid LCD 2X, Сетевое руководство

Страница: 13 / 43

4. For the Druid LCD 2x energizer:
a. Disconnect the energizer mains
and battery power. [1, 2]
b. Install the Nemlink board on top
of the battery brace and fasten
with 4 screws. [3]
c. Install the 10-way ribbon cable
between the energizer and
Nemlink board. [4]
d. Connect a keypad to the
energizer. [5]
e. Ensure the energizer is restored
to factory default:
i.
Reconnect the battery
power. [2]
ii. Reconnect the mains
power. [1]
iii. Within 60 seconds of reconnecting the power, enter 2389# on the keypad.
f. Enter installer mode by entering 012345*0# on the keypad. Ensure the
energizer LCD display turns purple. [6]
g. Configure the network address from by entering 51xx*#, where xx is the
address from 1 to 32. Energizer addresses must be chronologically
configured starting at 1. For example, three energizers on a network with
addresses 5, 18 and 22 is not allowed, as they need to be addressed 1, 2
and 3. Relay boards and energizers are addressed separately from 1 to 32.
h. Exit installer mode by entering *#. Ensure the energizer LCD display turns blue. [6]
i. Ensure the energizer network address is displayed on the LCD. [6]
j. Connect the energizer to a port on the ethernet switch (the port number does
not matter) with an ethernet cable. [7]
k. Route the ethernet cable out the bottom of the energizer enclosure and install
the lid.
6 Ethernet Network Setup C
6
3
2
13
1
7
4
5
3
6