Model Series: 8033SX-SLT / 8055SX-SLT Rollergrill
INTRODUCTION
1.
Please read instructions before using.
2.
This roller grill will be HOT during use and for a short time after it is turned off – BE CAREFUL!
INSTALLATION
1.
Set the roller grill on a flat surface.
2.
Position the roller grill near the power outlet. Avoid the use of extension cords.
3.
Plug the roller grill into a certified electrical outlet with a corresponding voltage rating as listed on the
roller grill model label.
4.
Clean the roller grill thoroughly before use.
OVERVIEW OF CONTROLS
1.
This machine has two zones, a front zone which is closest to the controls, and a rear zone which is
furthest from the controls. Each zone is designated by the color of the bearings, black bearings for the
front zone, and white bearings for the rear zone.
2.
There is one lighted rocker switch to turn the motor on for both zones.
3.
There are two thermostats to turn the heat on, one for each zone.
4.
There are two pilot lights to indicate when the heat is on, one for each zone.
STARTUP
1.
Turn on/off lighted rocker switch to the on position and make sure rollers are turning.
2.
Turn temperature controls to desired temperature
Knob setting #2: temperature is approximately 140º ; HOLD
Knob setting #4: temperature is approximately 160º ; HOLD
Knob setting #6: temperature is approximately 200º ; REHEAT
Knob setting #8: temperature is approximately 250º ; REHEAT
3.
Allow rollers to heat for 5 to 10 minutes before placing product on rollers.
4.
Use plastic to prevent serious damage to these rollers. Never use metal utensils or tools on the GripsIt
rollers.
5.
Once the product has finished reheating; turn the grill down to the hold zone. Never leave product on
reheat as it will overcook the product and dry it out.
CLEANING
1.
Turn the temperature controls on high and turn the rollers on before cleaning.
2.
ALWAYS START AT THE END OF THE ROLLERS AND WIPE TOWARD THE CENTER
. This prevents
extra grease from entering the sides of the roller grill and into the bearings.
Use a wet, soft cloth to wipe the rollers clean. NOTE: never use any metal object on the GripsIt rollers
at any time. Metal will cause serious damage to the rollers.
3.
After cleaning the rollers, remove the drip pan and clean with mild soap and water.
SERVICE INSTRUCTIONS
PREVENTATIVE MAINTENANCE
NOTE:
Proper maintenance plays an important part in the life span and functioning of the roller grill.
1.
The chains that drive the rollers should be inspected and greased once a year to be sure that they
continue to operate correctly. This will allow the machine to operate for a much longer time.
2.
IMPORTANT: Disconnect the roller grill from the power source before disassembly.
3.
Nemco offers a greasing kit, ordering number 80586. Alternatively, any food grade grease with a
temperature rating of at least 500°F can be used to grease the chains.
