NELSON
™
HEAT TRACING SYSTEMS
INSTALLATION
PLT-BC
STANDARD POWER CONNECTION KIT
INSTRUCTIONS
HLT PRODUCTS ALTERNATE STRIPPING METHOD
102mm (4")
Lightly cut around cable outer jacket 102mm (4")
from the end. Bend cable to break outer jacket.
Starting at the end, in the same plane as the cable,
pull each bus wire away from the core material.
Lightly cut the outer jacket up the center between
the first cut mark & the cable end. Bend cable to
break outer jacket.
Remove the exposed core material.
Remove the jacket from the heater cable.
Remove the remaining core material off the outside
of each bus wire.
Cut 6mm (0.25") off the end of each bus wire.
Make a cut inside each bus wire.
Proceed to
“Power Termination”
on sheet 7.
P.O. BOX 726 TULSA, OK 74101 TEL 918-627-5530 FAX 918-641-7336 www.nelsonheaters.com
GA-1859 Rev. 6
Sheet 6 of 8
October 2006
