Neitz IO-A LED, Руководство пользователя

Страница: 12 / 28

10 / 25
<Attaching using the Belt Hook>
The IO-BP
Ⅱ
may also be attached to a belt or the like by replacing the Headband Hook
with the Belt Hook.
Remove the Headband Hook from the IO-BP
Ⅱ
by unscrewing the 2 Hook Fixing Screws.
Then, affix the Belt Hook to the IO-BP
Ⅱ
by screwing the 2 Hook Fixing Screws into the
respective outer holes (see Fig. 3.3).
3.1.3 Connecting the IO-BP
Ⅱ
to the Scope Unit
(1) Holding the black rubber portion, insert the Lamp Plug into the Lamp Jack. Make
sure metal rings on the plug and jack interlock with a click (see Fig. 3.4).
*Note: The plug and jack interlock at a single configuration. Rotate the plug as
needed to connect smoothly.
(2) When using the Belt Hook, the Lamp Cord
attached to the Scope Unit is not long enough to
connect to the IO-BP
Ⅱ
. In this case, connect the
Extension Cord provided to the Lamp Cord to
accommodate. The Wiring Ring can be used to
keep the wiring from getting in your way (see Fig.
3.5).
(3) Gently pull the metal ring on the Lamp Plug to
disconnect from the IO-BP
Ⅱ
.
*Note: The cord will not disconnect by turning the
metal ring .
Fig. 3.3
Belt Hook
Note: Use the outer holes to
affix the Belt Hook.
Black Rubber
Portion
Fig. 3.4
Fig. 3.5
Wiring Ring
Extension Cord
Battery Pack
Lamp plug
Extension Cord Plug