- 11 -
STEP 7: Installing Control Rod
1. Push the handle gauge to the lowest position and insert the upper end of control rod into the hole
on the adjustable handle.
2. Remove one of nuts from threaded pole and insert the nut through the hole of pivot & bracket and
threaded pole and tighten.
3. Insert the threaded pole of adjustable pole B into the hole of adjustable plate, and then put the lock
nut M6 and flat washer Ø6.
4. Insert R Pin into the hole of turning axle at the bottom of hopper as shown.
STEP 8: Hopper Adjustments
When you finished all the above steps, you may find three holes at the bottom of hopper; match the three
holes with the adjustable plate.
If the holes do not match up do the following steps, Push the handle to the lowest position <downwards>
and adjust the positions of these two nuts on threaded control bar so the three holes at the bottom of
hopper closely match the three holes of adjustable plate (must closed properly).
