NEFF V5 HQ4 0 Series, Инструкция по применению

Страница: 22 / 28

en
Troubleshooting
22
1.
Hold the overflow container with one hand and un-
screw it with the other hand.
‒
Hold the overflow container level to prevent liquid
from leaking out.
2.
Empty the overflow container and rinse it out.
3. If required, unscrew the screw and clean the over-
flow container without the screw in the dishwasher.
4. Clean the overflow container before screwing it
back into place.
5. Ensure that the supply to the overflow container is
not blocked.
Remove any objects that have entered the appli-
ance once it has cooled down. To do this, remove
the grease filter.
T rou ble s h ootin g
25 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
→ "Customer Service", Page 24
WARNING ‒ Risk of electric shock!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord or the appliance power cable of
this appliance is damaged, it must be replaced with
a special power cord or special appliance power
cable, which is available from the manufacturer or
its Customer Service.
25.1 Warnings
Notes
¡
If or appears in the displays, press and hold the
sensor for the respective cooking zone and read the
fault code.
¡
If the fault code is not listed in the table, disconnect
the hob from the power supply and wait 30 seconds
before reconnecting it. If this display appears again,
contact customer service and specify the exact fault
code.
¡
If an error occurs, the appliance does not switch to
standby mode.
¡
In order to protect the appliance's electronic parts
from overheating or surge currents, the hob may
temporarily reduce the power level.
25.2 Information on the display panel
Fault Cause and troubleshooting
No displays light up. The power supply has been disconnected.
▶
Use other electrical appliances to check whether there has been a power failure.
The appliance has not been connected as shown in the circuit diagram.
▶
Connect the appliance in accordance with the circuit diagram.
Electronics fault
▶
If you are unable to rectify the fault, inform the technical after-sales service.
Ventilation system not
working
The appliance has not been connected as shown in the circuit diagram.
▶
Connect the appliance in accordance with the circuit diagram.
The displays flash. The control panel is wet or an object is covering it.
▶
Dry the control panel or remove the object.