FlexZone
en
13
10.4 Automatic mode with sensor control
The hob has an air quality sensor that automatically re-
gisters the cooking vapours and switches on the ventil-
ation system.
If the automatic start is switched off or is set in accord-
ance with the power levels, you can manually switch
this on with sensor control at any time.
Activating automatic mode with sensor control
1.
Press .
2.
Turn TwistPad® until lights up above .
The optimum performance level is set automatically
with the help of the button.
a
The function is switched on.
Deactivating automatic mode with sensor
control
1.
Touch .
2.
Use the twist knob to select another the perform-
ance level.
The display goes out.
a
The function has now been deactivated.
Note:
You can find out how to set the sensor sensitivity
in section
→
10.5 Run-on function for the ventilation
system
The run-on function leaves the ventilation system run-
ning for a few minutes after the hob has been switched
off. This allows you to remove any cooking fumes that
remain. The ventilation system then automatically
switches off.
The hob is supplied as standard with the run-on time
with a maximum switch-off time. You can find out how
to change this setting in section
→
Activating the fan run-on
The run-on time is configured in accordance with the
basic settings:
¡
Via the control for the air quality sensor. The dis-
play lights up.
¡
With a maximum switch-off time. The display above
the symbol lights up.
Note:
The run-on function only switches on if at least
one cooking zone has been switched on for at least
one minute.
Deactivating the fan run-on
Manually
To deactivate the function, touch .
Automatically
The appliance deactivates the run-on function when:
¡
The run-on time has elapsed.
¡
You switch the appliance on again.
¡
The sensor ensures that the air quality is in order.
11 FlexZone
The flexible cooking zone allows you to position cook-
ware of any shape or size any way you like. It consists
of four inductors that work independently of each other.
When the flexible cooking zone is in use, only the area
that is covered by cookware is activated.
11.1 Positioning the cookware
The flexible cooking zone can be configured in two
ways, depending on which cookware is used. In order
to guarantee good thermal detection and heat distribu-
tion, we recommend positioning the cookware in the
centre, as shown in the figures.
As a connected cooking zone
Recommended for cooking with just one item of cook-
ware.
¡
Position the cookware depending on the size:
¡
Recommended oblong cookware
:
As two separate cooking zones
Recommended for cooking with two items of cook-
ware.
You can use the front and rear zone independently of
one another, and set a separate power level for each
zone.
