NEFF T4.E2 Series, Инструкция по установке и эксплуатации

Страница: 28 / 48

28
To access the basic settings
The hob must be turned off.
1.
Switch on the hob.
2.
Within the next 10 seconds, press the ‚ symbol and hold for
4 seconds.
™‚
is displayed on the left of the screen and
‹
on the right.
3.
Press the ‚ symbol several times until the indicator for the
required function appears.
4.
Then select the required setting using the
+
and
-
symbols.
5.
Press the
‚
symbol again and hold for more than 4
seconds.
The settings will have been correctly saved.
Quit
To leave the basic settings, turn off the hob at the main switch.
Care and cleaning
The advice and warnings contained in this section aim to guide
you in cleaning and maintaining the hob, so that it is kept in the
best possible condition
Hob
Cleaning
Clean the hob after each use. This prevents food remains left
on the surface from burning. Wait until the hob is cold enough
before attempting to clean it.
Only use cleaning products specifically designed for glass-
ceramic hobs. Follow the instructions provided on the
packaging.
Do not use:
■
Abrasive products
■
heavy-duty cleaners, like oven sprays and stain removers
■
Pads that may scratch
■
High-pressure or steam cleaners
Glass scraper
Remove dried-on food remains using a glass scraper.
1.
Release the scraper safety catch
2.
Use the blade to clean the hob surface
Do not attempt to clean the hob surface with the base of the
scraper. This could result in scratching.
ã=
Risk of injury!!
The blade is extremely sharp. Risk of cuts. Protect the blade
when not in use. Replace the blade immediately when any
imperfections are found.
Care of the appliance
Apply an additive to protect and preserve the hob. Follow the
advice and warnings provided with the product.
™ˆ
Power-Management function
‹ = Deactivated.*
‚ = 1,000 W. minimum power.
‚ = 1,500 W.
ƒ = 2,000 W.
etc.
Š or Š . = maximum power of hob.**
™‹
Return to basic settings
‹
Personal settings.*
‚ Return to factory settings.
Indicator Function
*Factory settings
**The maximum power of the hob depends on the configuration of the installation's connection current. To not exceed this maximum
value, the hob includes a series of components that automatically control the power, distributing it between the hotplates in use
as required.