NEFF T4 D7B Series, Инструкция по эксплуатации

Страница: 12 / 36

en
Operating the appliance
12
1
Operating the appliance
Operating the appliance
This chapter explains how to set a hotplate. The table
shows heat settings and cooking times for various
meals.
Tip:
Switch on the ventilation system when you start
cooking and only switch it off a few minutes after you
have finished cooking. This is the most effective way to
remove the cooking vapours.
Note:
Never operate the appliance without the metal
grease filter and the overflow container.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: Touch the
#
symbol. An audible signal
sounds. The indicator next to the main switch and the
hotplate indicators ‹ light up. The hob is ready to use.
To switch off: Touch the # symbol until the indicator
goes out. All hotplates are switched off. The residual
heat indicator remains lit until the hotplates have cooled
down sufficiently.
Notes
■
The hob switches off automatically if all hotplates
have been switched off for more than 20 seconds.
■
The selected settings are stored for four seconds
after the hob has been switched off. If you switch it
on again during this time, the hob will operate using
the previously stored settings.
Setting a hotplate
Use the
@
and
A
symbols to select the required heat
setting.
Heat setting
‚ = lowest setting.
Heat setting Š = highest setting.
Every heat setting has an intermediate setting. This is
marked with a dot.
Notes
■
To protect the fragile parts of your appliance from
overheating and electrical overloading, the hob may
temporarily reduce the power.
■
In order to prevent the appliance from producing
excess noise, the hob may temporarily reduce the
power.
Selecting a hotplate and heat setting
The hob must be switched on.
1.
Select the hotplate using the
$
symbol.
2.
Touch the
@
or
A
symbol within 10 seconds. The
following basic setting appears:
@
symbol:
Š
heat setting
A
symbol:
…
heat setting
The heat setting is set.
Changing the heat setting
Select the hotplate and touch the
@
or
A
symbol until
the required heat setting appears.
Switching off the hotplate
Select the hotplate and then touch the
@
or
A
symbol
until
‹
appears.
The hotplate switches itself off and the residual heat
indicator appears.
Notes
■
If no pan has been placed on the hotplate, the
selected power level flashes. After a certain time has
elapsed, the hotplate switches off.
■
If a pan has been placed on the hotplate before
switching on the hob, it will be detected within
20 seconds of pressing the main switch and the
hotplate will be selected automatically. Once
detected, select the power level within the next
20 seconds or the hotplate will switch off.
If more than one pan is placed on the hob, only one
will be detected when switching it on.