NEFF T3 B4 Series, Инструкция по эксплуатации

Страница: 17 / 24

Cookware check
en
17
t
Cookware check
Cookware check
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1.
Place a cold saucepan containing approx. 200 ml of
water in the centre of the hotplate the diameter of
which matches the base of the pan most closely.
2.
Go to the basic settings and select the ™‚ ƒ setting.
3.
Touch the @ or A symbol. A will flash on the hotplate
display.
The function has now been enabled.
After 20 seconds, the quality and speed of the cooking
process will appear in the hotplate display.
Check the result using the following table:
To activate the function again, select the
@
or
A
symbol.
Notes
■
If the diameter of the hotplate used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
■
You can find information on this function in the
section on
~
"Basic settings" .
■
You can find information on the type, size and
positioning of the cookware in the section on
~
"Induction cooking" .
h
Power manager
Power manager
You can use the power manager function to set the
total power of the hob.
The hob settings are preconfigured at the factory. Its
maximum performance is specified on the rating plate.
You can use the power manager function to change the
value to meet the requirements of the specific electrical
installation.
In order not to exceed this set value, the hob
automatically distributes the power available according
to need between the cooking zones that are switched
on.
While the power manager function is activated, the
output of a cooking zone may temporarily fall below the
nominal value. If a cooking zone is switched on and the
power limit is reached, ¬ appears in the power level
display for a short time. The appliance automatically
regulates and selects the highest possible power level.
Note:
If automatic power limitation has been activated,
the appliance self-regulates but continues to display the
selected power level unchanged.
For more information about how the total power of the
hob is changed, see the section entitled
~
"Basic
settings"
Result
‹
The cookware is not suitable for the hotplate and will therefore
not heat up.*
‚
The cookware is taking longer to heat up than expected and the
cooking process is not going as well as it should.*
ƒ
The cookware is heating up correctly and the cooking process
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.