NEFF N 70 D46ML54N0B, Инструкция по установке и эксплуатации

Страница: 8 / 20

en
Cleaning and maintenance
8
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off. In addition, this
symbol is indicated on the display:
ª
If you have not yet done so, the metal mesh grease
filters should be cleaned now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section
Cleaning and
maintenance
.
While the saturation display is flashing, it can be reset.
To do this, press the – button.
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the
#
and + at the
same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
2
Cleaning and maintenance
Cleaning and maintenance
:
Warning – Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
:
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
■
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.