NEFF K367 Series, Руководство пользователя

Страница: 22 / 66

en
22
Disconnecting the appliance
If you do not use the appliance
for a prolonged period:
1. Switch off the appliance.
2. Pull out mains plug or switch off fuse.
3. Clean the appliance.
4. Leave the appliance door open.
Cleaning the appliance
m
Caution
■
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
■
Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
■
Never clean shelves and containers
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out mains plug or switch off fuse.
3. Wait until the layer of frost has thawed.
4. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light or through
the drainage hole into the evaporation
area.
5. Wipe the door seal with clear water
only and then wipe dry thoroughly.
6. Rinsing water must not run through
the drainage hole into the evaporation
area.
7. After cleaning reconnect and switch
the appliance back on.
Note
Regularly clean the condensation
channel and drainage hole, Fig.
#
, with
a cotton bud or similar implement
to ensure that the condensation can
drain.
Tips for saving energy
■
Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
■
Select 560 mm cavity depth.
A smaller cavity depth will result in
a higher energy consumption.
■
Allow warm drinks to cool down
before placing in the appliance.
■
Open the appliance as briefly as
possible.
■
To avoid increased power
consumption, occasionally clean the
back of the appliance.
■
The arrangement of the fittings does
not affect the energy rating of the
appliance.