Cleaning and maintenance
en
7
Fan run-on time
Touch the - symbol until
‚
9
appears.
After approximately 10 minutes, the fan switches off
automatically.
AirFresh function
Touch the
3
symbol until the
‚
3
appears. The
fan runs for approximately five minutes per hour.
Touch the
3
symbol if you want to end the AirFresh
function.
Noise reduction function
The noise reduction function reduces the fan noise.
Switching on
Touch the
4
symbol.
This function is possible at all fan settings except fan
setting
‚
. This function also remains active after the fan
is switched off.
Switching off
Touch the
4
symbol.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
6
symbol.
Setting the brightness
Press and hold the
6
symbol until the required
brightness is reached.
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
The following symbols also appear on the display:
”ªª
(metal grease filter) or
’ªª
(activated charcoal filter).
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section:
Cleaning and maintenance
.
The saturation indicator can be reset while it is flashing.
To do this, touch the - symbol.
Switching over the indicator for circulating-air mode
For circulating-air mode, the electronic control must be
switched over accordingly:
■
The extractor hood must be connected and switched
on.
■
Touch and hold the
#
and
‘
symbols at the same
time, until the
’‹–
indicator lights up for the
circulating-air mode "Starter Set". Repeatedly
pressing and holding this button combination
causes the
’–‘
indicator to light up for the
"CleanAir" circulating-air module.
■
Repeatedly pressing and holding this button
combination switches the electronic control back
over to ducted operation (
”‚–
indicator).
Audible signal
Switching on the audible signal
Touch and hold the
#
and + symbols at the same time
for approximately three seconds when the fan is
switched on. An audible signal sounds as an
acknowledgement.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
2
Cleaning and maintenance
Cleaning
and maint
enance
:
Warning
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
:
Warning
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
Observe the information in the table to ensure that the
different surfaces are not damaged by using the wrong
type of cleaning agent. Do not use
■
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
