NEFF D87ER22N0B/02, Инструкция по установке и эксплуатации

Страница: 6 / 16

en
Operating the appliance
6
1
Operating the appliance
Operating the appl iance
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
Note:
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel
Control panel
Setting the fan
Switching on
Press button 1, 2 or 3.
Switching off
Press the 0 button.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the
˜
button.
The run time is limited. The fan is then automatically
reduced to a lower fan setting. You can switch back
manually at any time.
Lighting
The lighting can be switched on and off independently
of the ventilation.
Press the
A
button.
2
Cleaning and maintenance
Cleaning and maint enance
:
Warning
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
:
Warning
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
■
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Explanation
A
Light On/Off
0.1 Fan Off/Fan speed 1
2
Fan speed 2
3 Fan speed 3
Explanation
A
Light On/Off
0 Fan off
1 Fan speed 1
2 Fan speed 2
3 Fan speed 3
P Intensive setting
3
Area Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with a
soft cloth.
Clean stainless steel surfaces in the grind
direction only.
Special stainless steel cleaning products are
available from our after-sales service or from
specialist retailers. Apply a very thin layer of
the cleaning product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plastic Glass cleaner:
Clean with a soft cloth.