Installation instructions
en
15
12.11 Information about circulating-air
mode
If the appliance is used in circulating-air mode, the
blow opening must be secured using a ventilation
grille. The ventilation grille prevents mechanical and
electrical hazards.
12.12 Installation
Checking the surround
1.
Check whether the surround is horizontal and has
sufficient load-bearing capacity.
The maximum weight of the appliance is 15 kg.
2.
Check whether the surround covers the entire cook-
ing surface.
3.
Check whether all of the walls of the surround are at
least 15 mm thick.
4.
Ensure that the surround is still stable after the cut-
outs have been made.
Installing the air-pipe connector
Requirement:
The appliance has a rectangular air out-
let.
▶
Screw in the air-pipe connector above the rectangu-
lar air outlet.
The air-pipe connector is enclosed.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
Requirement:
The grease filters have been removed.
"Removing the grease filter", Page 7
1.
Connect the appliance to the power supply.
2.
Push the appliance up into the surround until the
mounting springs at the front and rear click into
place.
3.
Screw the appliance into place.
4.
Ensure that the lower edge of the appliance is flush
with the surround.
5.
If the appliance has a spacer rail, insert this.
6.
Install the grease filters.
→
"Installing the grease filters", Page 8
Piping
Note:
If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend the piping with an exhaust air pipe dia-
meter of 150 mm.
Establishing the exhaust air connection (exhaust air
pipe, 150 mm diameter)
1.
Secure the exhaust pipe to the air pipe connector.
2.
Establish the connection to the exhaust air opening.
3.
Seal the joints.
Establishing the exhaust air connection (exhaust air
pipe, 120 mm diameter)
1.
Secure the reducing connector to the air-pipe con-
nector.
2.
Secure the exhaust air pipe to the reducing con-
nector.
3.
Establish the connection to the exhaust air opening.
4.
Seal the joints.
Removing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
Requirement:
The grease filters have been removed.
"Removing the grease filter", Page 7
1.
Disconnect the appliance from the power supply.
2.
Undo the screws.
3.
Loosen the pipework.
4.
Hold the appliance at the bottom. Pull at the front
and rear of the mounting springs.
5.
Slowly take the appliance down.