NEFF C18FT56.0B, Инструкция по эксплуатации

Страница: 18 / 60

en
Steam
18
Cancelling
Press and hold the
#
touch button until the appliance
operation is cancelled.
Finishing
Touch the
#
touch button to switch the appliance off.
Filling the water tank
The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly.
~
"Basic settings" on page 22
:
Warning
Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
:
Warning
Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Notes
■
If your water is very hard, we recommend that you
use softened water.
■
If you use only softened water, you can set your
appliance to the "softened" water hardness range.
■
If you use mineral water, set the water hardness
range to "4 very hard".
■
If you use mineral water, you must only use non-
carbonated mineral water.
1.
Touch the
”
touch button.
The control panel is automatically pushed forwards.
2.
Pull the control panel forwards with both hands and
then push it upwards until it locks into place (Fig.
!
).
3.
Lift the water tank and remove it from the water tank
recess (Fig.
"
).
4.
Fill the water tank with cold water up to the “max.”
mark (Fig.
#
).
5.
Insert the filled water tank (Fig.
$
). Ensure that the
water tank locks into place behind both holders
‚
(Fig.
%
).
6.
Slowly push the control panel downwards and then
towards the rear until it is closed completely.
The water tank has been filled. You can start
operations with steam.
Refilling the water tank
If the water tank runs dry during a steam operation, a
message appears on the display prompting you to fill
up the water tank.
Notes
■
Steam-assisted operations continue without adding
steam.
■
If the water tank runs dry during operation with the
Steaming, Dough proving, Defrost or Reheat
settings, operation is interrupted. Fill the water tank.
1.
Open the control panel.
2.
Remove and refill the water tank.
3.
Insert the filled water tank and close the control
panel.
2I 1
I
D
D
I