Installation instructions
en
37
24.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡
The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35 mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡
Ventilation slots and intake openings must
not be covered.
¡
The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡
Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡
Proceed in accordance with the installation
sheets for installing accessories.
¡
Fitted units must be heat-resistant up to
95 °C, and adjacent unit fronts up to
70 °C.
¡
Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡
The mains socket for the appliance must
either be located in the hatched area or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket .
¡
Wear protective gloves so that you do not
cut yourself. Parts that are accessible dur-
ing installation may have sharp edges.
¡
Dimensions of the figures in mm.
WARNING ‒ Danger: Magnetism!
Permanent magnets are used in the control
panel or in the controls. They may affect elec-
tronic implants, e.g. pacemakers or insulin
pumps.
▶
Wearers of electronic implants must stay at
least 10 cm away from the control panel or
controls during the installation.
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶
Do not use multiple socket strips.
▶
Only use extension cables that are certified,
have a minimum cross section of 1.5 mm²
and comply with the applicable national
safety requirements.
▶
If the power cord is too short, contact cus-
tomer service.
▶
Only use adapters approved by the manu-
facturer.
ATTENTION!
Carrying the appliance by the door handle
could break it. The door handle cannot sup-
port the weight of the appliance.
▶
Do not carry or hold the appliance by the
door handle.
Содержание C17MS22N0
Страница 1: ...Oven en User manual and installation in structions C17MS22N0 ...
Страница 41: ......
Страница 42: ......
Страница 43: ......