NEFF B59FS3A 0 Series, Руководство пользователя и инструкции по установке

Страница: 57 / 60

Installation instructions
en
57
29.13 Aligning the panels and intermediate
strips
The panels and intermediate strips are aligned at the
same time.
Requirement: The appliance must not yet be screwed
in tightly. If it is already screwed in tightly, undo the
fastening screws.
▶
From the rear, turn the fastening elements to the
right or left to adjust the alignment of the panels and
intermediate strips.
29.14 Removing the door handle and side
panels
ATTENTION!
Unsuitable tools may damage the surface of the appli-
ance.
▶
Only use plastic tools.
▶
Do not use pointed or sharp tools.
1. Loosen the screws on the door handle and remove
the door handle.
2. Remove the left- and right-hand panels using a
plastic tool.
29.15 Removing the appliance
1. Disconnect the appliance from the power supply.
2.
Remove the left- and right-hand panels.
3. Undo the fastening screws.
4.
Lift the appliance slightly and pull it out completely.