NEFF B47CS36 0B Series, Инструкция по эксплуатации

Страница: 26 / 48

en
Appliance door
26
3.
Turn the door handle upwards slightly
‚
so that the
appliance door slides downwards fully
ƒ
(Fig.
#
).
4.
Use a coin to release both locks on the appliance
door (Fig.
$
).
Left lock: Anti-clockwise
Right lock: Clockwise
5.
Open the appliance door a little wider and then close
it.
:
Warning
Risk of injury from hinge locks which have not
been properly closed!
The appliance door may detach itself. You may be
injured and the appliance door damaged. After
refitting the door, always close the left- and right-
hand hinge locks.
6.
Close the left- and right-hand hinge locks (Fig.
%
).
To do this, push the hinge lock downwards on both
sides with a screwdriver (Fig.
&
).
Removing and installing the door panels
For cleaning, you can remove the glass panels from the
appliance door.
To do this, the appliance door must be removed
beforehand (see section "Removing and fitting the
appliance door").
:
Warning – Risk of injury!
The appliance must not be used again until the door
panels and appliance door have been correctly fitted.
:
Warning – Risk of injury!
Components inside the appliance door may have sharp
edges. Wear protective gloves.
Removal
Note:
Lay the removed glass panels on an even, soft
and clean surface.
1.
Remove the appliance door.
2.
Lay the appliance door with the front side facing
down on an even, soft and clean surface.
3.
Push on the left- and right-hand side on the outside
of the appliance door until the inner glass is
released on both sides (Fig.
!
).
4.
Carefully lift the inner glass and remove it in the
direction of the arrow (Fig.
"
).
5.
Push the intermediate panel downwards in the
‚
area, carefully lift the
ƒ
holder until it can be pulled
out (Fig.
#
).
6.
Lift the intermediate panel from below (Fig.
$
) and
remove it.
7.
Clean all panels on both sides with glass cleaner
and a soft cloth.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, or sharp or
abrasive cleaning aids or detergents.
8.
Dry and refit all panels.
II I
D
E
I
2 1
E
D