Neets Control SieRRa DK, Руководство пользователя, Страница: 10 / 10

Page 9 Doc. no#: 310-0100-004-001 R200 Manual
Fault Solution
System are in boot
mode
You have put the system in boot mode.
This mode allows you to communicate with the system
using Rx1/Tx1. To get the system in boot mode, hold down
all 4 corner buttons for more than 2 seconds (2 in the top,
and 2 in the botton).
System are resuming
factory default
settings
When pressing Switch 1 and 4 during power on,
the system will delete the current settings and resume
factory default.
This method are only intended to be used, if the control
system lock up and enters “Unexpected Error”.
System log file
The Neets Control – SieRRa has a log file, which contains information, warnings and errors that the system
encounters during run.
The log file looks like below:
To give you the best support possible we recommend that you have access to the log file, when contacting
support.
There are two ways to get access to this file:
uSD-card:
If you put the uSD-card into your computer you find the log file here: Drive\System\Log.txt
HTTP:
Enter the following address into your browser: http://xxx.xxx.xxx.xxx//System/Log.txt.
xxx.xxx.xxx.xxx are the IP address of your Neets Control – SieRRa.
Remember the two“//”.