Nederman E Series, Инструкция по эксплуатации

Страница: 19 / 210

E - Vacuum Cleaners
19
EN
Part number Area (A)
(m²)
Diameter
(D) (mm)
Length (L)
(mm)
Material EN 60335-2-
69/EN1822
Max.
temp.
(°C)
Washable**
43110300 0,59 x x Polyester (Figure 3 B) M 120 -
43110400 0,59 x x Antistatic Polyester (Figure 3 B) M 120 -
*See label on filter for part number.
**Replace the cartridge filter after it has been washed twice.
4 Installation
WARNING! Risk of personal injury.
• Bolt non-mobile vacuum cleaners firmly to a hard flat surface.
• Do not place vacuum cleaner on an uneven or sloping surface.
• Always use proper lifting equipment and protective gear when assembling your
configured product.
• Always use proper lifting equipment when using lifting lugs to lift vacuum cleaners.
•
Use a forklift to transport vacuum cleaners with a stand or trolley, unless the vacuum
cleaner is equipped with eye bolts.
• Always use proper lifting equipment when using lifting lugs to lift vacuum cleaners.
• Use a forklift to transport vacuum cleaners with a stand or trolley, unless the vacuum
cleaner is equipped with eye bolts.
CAUTION! Risk of equipment damage.
•
Do not load the handles with more than 75 kg. See figure 16 .
• Do not hang bulk bags by their corner straps. Straps are only intended to keep the bag
from collapsing. The weight of the collected dust/material must be supported by the
pallet, see figure 6 (C).
• If wet material is to be vacuumed, use a float ball and filter designed for that purpose.
•
Use the correct filter for collecting wet material.
• Turn off vacuum cleaner if liquid or foam escapes from it.
NOTE!
• Follow local rules and regulations for all steps in the installation process.
• Note! For electrical connections, see Figure 5
4.1 Bulk-bags and holders
WARNING! Risk of personal injury.
• Always use approved bulk bags.
•
Connect the upper and lower ground wires to the bag.
CAUTION! Risk of equipment damage.
Do not hang bulk bags by their corner straps. Straps are only intended to keep the bag from
collapsing. The weight of the collected dust/material must be supported by the pallet.