TRANSIT Ultimate | installation guide
30/40
6.2
Range beeper
Enable or disable the internal range beeper. The beeper indicates transponder identification. The signal strength of the
identified transponder determines the beeping frequency. When the transponder is near to the reader the range beeper
will beep fast
ON
1 2 3 4
SW2
ON
1 2 3 4
SW3
Range beeper ON
ON
1 2 3 4
SW2
ON
1 2 3 4
SW3
Range beeper OFF
6.3
Serial communication select
By default the USB or communication interface board connections will allow communication with the TRANSIT
processor (PIC). The communication protocol is determined by the TRANSIT firmware.
The USB or communication interface board connections can also be used to communicate with the processor located
on the TAB board. This is for test purposes and will not further be explained in this manual. Note that while the USB
cable is connected, the communication interface board is disabled.
ON
1 2 3 4
SW2
ON
1 2 3 4
SW3
TRANSIT communication (PIC)
ON
1 2 3 4
SW2
ON
1 2 3 4
SW3
Test communication (TAB)
