ANPR ACCESS | INSTALLATION GUIDE
Configuration
27/36
5.3
SYSTEM CONFIGURATION
5.3.1
NETWORK
The Network Settings page contains the following configuration fields:
Network
NetBiosName
It allows setting the name of the ANPR device. It is
possible to enter alphanumeric values in this field. Spaces
must be represented by "_" (underscore).
IpAddress
It allows setting the IP address of the ANPR device.
NetMask
It allows setting the network net mask.
Gateway
It allows setting the gateway IP address.
DhcpEnable
It allows enabling/disabling automatic acquisition of IP
addresses.
Time Server
Syncro
This feature enables/disables the synchronization to an
external timeserver.
IpAddress
Indicates the IP address of the time server which is used
as reference to synchronize the ANPR's internal clock.
GMT Offset
Indicates the number of minutes to add to the time
received from the time server, in order to offset between
"Greenwich Mean Time" and local time. This value is
expressed in minutes and can be negative. See
http://wwp.greenwichmeantime.com
for further details on
time zones for different countries around the world.
Auto DST
Automatically adjust clock for daylight saving changes. If
set to YES, it automatically handles switching between
daylight-saving time and standard time.
5.3.2
HTTP USERS
Three user access levels are available:
Superuser
The superuser is allowed to access all system-enabled
features, modify operational parameters (setup) and
assign access rights to other users.
Administrator
The administrator has the rights to modify any all
operational parameters but is not allowed to access the
HTTP Users page.
Guest
Guest users are only allowed to view the system
parameters.
Access to HTTP Users page is granted to the superuser only, who is allowed to
enable, disable or delete users or to assign new passwords. Up to ten administrator
and/or guest users can be assigned to the system and only one superuser account.
The HTTP Users page contains the configuration settings of the users who access the
ANPR via a browser.
Server Port:
The port number where the http server is open. Default
value is 80.
Name:
User's username.
Password:
User's password.
Status:
User's access level. Can be ADMIN, GUEST or DISABLED.