![background image](http://html2.mh-extra.com/html/nectre-fireplaces/n65/n65_operating-instructions-manual_3839214007.webp)
iv)
Starting with the end that has the sliver tape around it,
press the new door seal rope into the groove on the
door.
v)
When get to the end there will be a small amount of
excess rope. Trim this to the right length, remove the
backing from the adhesive silver tape supplied with
the rope and wrap the tape around the end that has
been trimmed. Fit the end of the rope into the groove.
vi)
Refit the door if it has been removed and close.
If the door does not close firmly, then the door latch can be
adjusted.
With the 4mm allen key supplied, slightly loosen the two
screws fastening the latch to the side of the firebox body.
Gently tap the latch only a millimetre to start with.
Retighten the screws and test for any improvement. If no
improvement, repeat process until door can be closed
firmly.
Firebricks:
Refractory Bricks
2 x bricks – 270(h) x 175(w) x 25(d)mm
Vermiculite Bricks
2 x bricks – 263(h) x 165(w) x 25(d)mm
4 x bricks – 270(h) x 130(w) x 25(d)mm
Brick Retainer:
LH & RH each ‘L’ shaped
300mm x 195mm
Upper Baffle
Plate:
300(w) x 200(d) in 6mm steel
Lower Baffle
Plate:
395(w) x 260(d) in 6mm steel
Ceramic
blanket:
305(w) x 220(d) x 25(h) high temperature
ceramic blanket
Glass seal:
1840mm x 19mm x 3mm flat adhesive back
Glass:
431mm x 325mm x 5mm
Door rope:
1500mm x 13mm round braided ceramic
rope
5. ADJUSTING DOOR LATCH
6. REPLACEMENT SPARE PARTS LIST