![background image](http://html1.mh-extra.com/html/nectre-fireplaces/form-2-series/form-2-series_operating-instructions-manual_3825473010.webp)
8
3.
FITTING A NEW DOOR SEAL
Remove the door from the heater and lay it horizontally on
a work-bench.
1.
Remove any old seal from the door.
2.
Clean out the groove in the door that held the seal
using a flat-end screw driver or equivalent.
3.
Run a thin bead of clear roof and gutter silicone
along the groove.
4.
Starting at one end, press the new door seal rope
into the groove on the door.
5.
Refit the door and close.
APPLY SILICONE
4.
FITTING NEW DOOR GLASS
To replace the door glass, remove the door from the heater
and lay it horizontally on a work-bench.
1.
Six small stainless steel tabs hold the glass in place.
Remove the screws from the stainless steel strips
with a 4mm hex key.
2.
Take out the glass, and the flat grey glass seal rope
beneath it. The glass replacement kit will come with
replacement glass seal.
FIBREGLASS ROPE
3.
Position the new glass on top of the replaced glass
seal and re-fit the stainless steel tabs and screws.
4.
Hand-tighten the screws until firm. Take extra care
not to over-tighten the screws, otherwise the glass
will crack when the heater gets hot and the door
expands.
5.
Dispose of the old glass in a responsible manner,
and re-fit the door to the heater.
Содержание Form 2 Series
Страница 1: ...PREMIUM PORTRAIT WOOD HEATER OPERATING INSTRUCTIONS...
Страница 14: ...12...
Страница 15: ...13...