NEC UNIVERGE WL, Быстрое руководство по установке

Страница: 10 / 34

1-4
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
• Preparing a Version 2.0 UNIVERGE WL AP or UNIVERGE WL 1200R or
Alternate Preparing a Version 2.0 UNIVERGE WL AP or UNIVERGE WL
1200R for installation in a Version 2.0 UNIVERGE WL System
If you are unable to perform either of previous procedures, refer to the RMA
Procedures in the UNIVERGE WL Product Documentation.
Preparing a Version 1.2 UNIVERGE WL AP
Preparing a Version 1.2 UNIVERGE WL AP
If your UNIVERGE WL AP has UNIVERGE WL Operating System 1.2 or an earlier
version loaded on it, or if you do not know what version the AP has loaded on it,
use this procedure. If your AP is a UNIVERGE WL 1200R or has UNIVERGE WL
Operating System 2.0 or later loaded on it, use the
Preparing a Version 2.0
UNIVERGE WL AP or UNIVERGE WL 1200R procedure below.
Configuration Setup
Configuration Setup
Does My Configuration Qualify for this Procedure?
Does My Configuration Qualify for this Procedure?
• You must have a version 2.0 UNIVERGE WL Wireless Controller on its
own subnet that can be reconfigured back and forth between Layer 2
and Layer 3 LWAPP operation. If you do not have a spare or depot
UNIVERGE WL Wireless Controller that can be reconfigured back and
forth between Layer 2 and Layer 3 operation, refer to RMA Procedures
later in this document to RMA your version 1.2 UNIVERGE WL APs.
• Alternatively, you may have a version 2.0 UNIVERGE WL Wireless
Controller that is part of a mobility group that can be reconfigured back
and forth between Layer 2 and Layer 3 operation. If you do not have a
mobility group of UNIVERGE WL Wireless Controllers that can be recon-
figured back and forth between Layer 2 and Layer 3 operation, refer to
RMA Procedures later in this document to RMA your version 1.2
UNIVERGE WL APs.
NOTE
This procedure assumes that you are preparing a version 1.2 UNIVERGE
WL AP to inter-operate with a version 2.0 UNIVERGE WL Wireless
Controller. When you are preparing a version 1.2 UNIVERGE WL AP to
inter-operate with a version 1.2 UNIVERGE WL Wireless Controller, use
the procedure found in the version 1.2 UNIVERGE WL Access Point Quick
Installation Guide.