NEC Univerge SV9100, Руководство по аппаратному обеспечению системы

Страница: 249 / 556

Issue 2.0
SV9100 System Hardware Manual 4-11
2.6.3.2 Port Defaults
With the default settings, the ports are assigned as follows:
In the initial configuration:

All Programmable Function keys are line keys (e.g., key 1 is
line 1).

All trunks are loop start DTMF.
2.6.3.3 Setting Up Extension Circuit Types
Run Program 10-03 to set up extension circuit types as
required. The system automatically detects and assigns most
circuit types when the device is connected.
1. Dial 10-03-01.
2. Press TRANSFER to Select the slot, port or channel (with
ESIU Blades) to be programmed.
3. Set the terminal type or option as needed.

If the system has DSS Consoles, Program 30-02 must be
used to define DSS extension assignments.
As the system recognizes the extension devices automatically,
when replacing the connected device, it must be undefined in
Program 10-03 prior to connecting the new device. For
example, if a port was previously used for a telephone and a
DSS Console is to be installed in that same port, the telephone
must first be undefined in Program 10-03 before the console is
connected.
2.6.3.4 Saving Your Configuration
When programming is completed, to exit out of the program
option and save changes to the GCD-CP10:
1. Press
EXIT
to exit the program options, if needed.
2. Press
Speaker
.
Saving System Data is displayed if changes were made to
system programming.
3. The display shows Complete Data Save when completed
and the telephone becomes idle.
Table 4-4 Default Port Settings
Station Ports:
Port 1~300 : 200~499
Port 301~960 : 5000~5659
Virtual Station
Ports:
Port 1~99 : 201~299
Port 100~512 : No Setting
Trunk Ports:
1~400