NEC SV8500, Руководство пользователя

Страница: 1030 / 3438

VOL.2-777
MG-BRI
16. SET WARNING_TONE_CONTROL
:
Assignment of warning tone
Assign whether to use warning tone when LAN failure or not.
Note:
Execute the “SAVE” command before finishing the maintenance command to reflect change.
• The following commands are available for MG-BRI with the firmware versions: SP-3709 BRI MG BSC
PROG-A Issue 18 or later and SP-3708 BRI BOOT PROG-A Issue 8 or later.
1. SET CALL_HOLD
:
Assignment of MG Based Call Retention
Enable/Disable MG Based Call Retention.
Note:
When “Enable” is set and a network error occurs between the Telephony Server and MG-BRI, an ongoing
call can be retained, but the MG-BRI will not re-register to the Telephony Server.
Note:
Execute “SAVE” command before exiting the maintenance command and reboot MG-BRI to enable the
new setting.
2. SET RTP_STOP_DETECT
:
Assignment of RTP Receive Stop Detect timer
Assign RTP Receive Stop Detect timer used for MG Based Call Retention.
Note:
This timer value is one of the conditions to determine the end of an ongoing call. When receiving no RTP
signal for longer than the set value, MG determines that a call ends.
Note:
Execute “SAVE” command before exiting the maintenance command and reboot MG-BRI to enable the
new setting.
MG-BRI>set warning_tone_control P1
P1: Setting of Mode (Default: 3)
0: Do not send warning tone
1: Send warning tone to IPNW side.
2: Send warning tone to ISDN side.
3: Send warning tone to IPNW and ISDN.
MG-BRI> SET CALL_HOLD P1 P1: ENABLE/DISABLE
ENABLE: MG Based Call Retention is valid.
DISABLE: MG Based Call Retention is invalid
(default).
MG-BRI> SET RTP_STOP_DETECT P1 P1: Setting of Time (seconds) (at intervals of a
second)
Range: 3-32 seconds (default: 3 seconds)