Installation Guide
QX-S5500 Series Ethernet Switches
1.5.4 1-port 10G BASE-XFP interface module (LS-XP1-T2)
Figure 1-17
1-port 10G BASE-XFP interface module (LS-XP1-T2)
Figure 1-18
1-port 10G BASE-XFP interface module front panel (LS-XP1-T2)
This module provides one 10 Gbps XFP optical interface. You can select the following XFP
transceivers as required. A 1-port 10 GE XFP interface module provides one 10 Gbps XFP
optical port. You can insert an XFP transceiver into the port to connect it to another XFP
port through an optical fiber. You can select the XFP transceivers list in Table 1-16 as
required.
1.5.5 Description of LEDs of Interface Modules
NOTE:
At software Version 5.4.16 or later Version, when a loop was detected at the port where a loopback detection
feature is effective, while port mode is rate mode or duplex mode Ethernet Port Status LED flashes on and off
by the cycle for about 2 seconds greenly.
There is a LED for each port on the interface module panel. Table 1-17 describes the LEDs.
Port LED
Port LED
1-16
