23
2. Projecting an Image (Basic Operation)
Focus
Recommend to perform the focus adjustment after leaving the projector under the state the TEST PATTERN has
been projected for over 30 minutes.
Please refer to page
in the User’s Manual about the TEST PATTERN.
1. Press the FOCUS (+) or (−) buttons to adjust focus.
• On the remote control, while pressing on the CTL button, press on VOL/FOCUS (+) or (−) button.
TIP:
• To obtain the best focus, perform the following (for permanent installation)
Preparation: Warm up the projector for one hour.
1. Use the FOCUS (+) or (−) buttons to make sure you obtain the best focus. If you do not, move the projector back and forth.
2. Select the [TEST PATTERN] from the menu and display the test pattern. (
→
• You can also use the TEST button on the remote control to display the test pattern.
3. Press the FOCUS (−) button until the pixel lattice of the test pattern cannot be seen any more.
4. Keep pressing the FOCUS (+) button until you obtain the best focus.
If you adjust beyond the best focal point, go back to step 3 and repeat the procedures.
