NEC PA1004UL-W, Руководство по установке

Страница: 32 / 41

1. Attachment/detachment of parts sold separately
32
1-2. Option cover
Model name of option cover
NP13CV-W for PA1004UL-W/PA804UL-W
NP13CV-B for PA1004UL-B/PA804UL-B
The option covers A and B are packaged with the option cover NP13CV-W and NP13CV-B.
For the following cases, attach the separately sold option cover to the projector.
Option cover A
• To make the appearance clean by covering the connected
cables
• To install the projector with its rear upward or downward
Option cover B
• To install the projector with its exhaust vents upward or down-
ward
For installation angles required to attach the option cover, refer to page 24 .
WARNING
• When installing the projector at an angle, be sure to attach the option cover for safety.
• Be sure to attach the option cover to the projector when the projector's power is turned on.
CAUTION
About option cover
• After attaching the option cover to the projector, be sure to tighten the screws. If you fail to
do so, the option cover may come off and cause injury, or the option cover may fall and cause
damage.
• Do not bundle the power cord and place it under the option cover. Doing so could lead to fire.
• Do not move the projector by holding the option cover or do not use excessive force to the
option cover. Doing so can cause damage to the option cover, resulting in injury.
Preparations:
• Connect the cables to the projector (the connection cords are omitted from the diagrams).
At this moment, do not connect the power cord.
• Prepare a Phillips screwdriver.
• Place the projector on a soft cloth so as not to scratch the cabinet surface.