4. Using On-Screen Menu
68
TIP:
• Brightness normally decreases with use, but by selecting [CONSTANT BRIGHTNESS] mode, the projector automatically adjust the
output based on the projector used time, thereby maintaining a constant brightness throughout the life of the light module.
However, if output is already at its maximum, brightness will decrease with use.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00,
8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES.] message will be displayed on the bottom of the screen.
Setting the date and time [DATE AND TIME SETTINGS]
Display the start-up screen of MultiPresenter (
→
page
Configuring the menu settings [ADMINISTRATOR MODE]
This allows you to select [MENU MODE], save settings, and set a [KEYWORD] for the [ADMINISTRA-
TOR MODE].
MENU MODE
Select either [BASIC] or [ADVANCED] menu. (
→
)
NOT SAVE SETTING VALUES
When [ON] is selected, the values of the items configured in the on-screen menu will not be saved.
KEYWORD
Assign a password for the administrator mode. Enter the password using the
▲▼◀▶
buttons
and press the ENTER button. (Up to 10 alphanumeric characters)
Selecting Menu Language [LANGUAGE]
You can choose one of 30 languages for on-screen instructions.
NOTE:
• Your setting will not be affected even when [RESET] is done from the menu.
