30
7. NETWORK SETTINGS
7-5. MultiPresenter
Configure the settings when using MultiPresenter.
About the modes
• The Free mode is a mode in which you can connect freely to the projector from the MultiPresenter application
installed on your computer or smartphone.
The screen splitting pattern will vary depending on the number of terminals that are connected. It is also possible
to select the split display or the full-screen display from the terminal.
• The Managed mode is a mode in which the operations for switching back and forth between the split-screen display
and the full-screen display when multiple terminals are connected to the projector simultaneously, like in the Free
mode, can be performed using the projector's “Web Server” function.
Item
Description
Remarks
Mode
Select the operating mode.
Free: Set the free mode.
Control: Set the managed mode.
The default factory setting when
shipped is “Free”.
HTTP Password
Able to setup a password to log in the MANAGED MODE for
the MultiPresenter in the WEB SERVER functions
Max 32 alphanumeric charac-
ters. If it leaves in blank, the
password becomes "Null". De-
fault setting: Blank
PIN TYPE
• ONE-TIME
A 4-digit PIN code is generated automatically. The PIN
code is generated when the projector is turned on, and is
retained until the power is turned off.
• STATIC
Set any 4-digit PIN code.
• By factory default, this is set
to [ONE-TIME].
PIN CODE
When [STATIC] is selected at [PIN TYPE], set any PIN code. • The pin code must consist of
4 numbers.
UTILIZE PIN CODE
AS CONNECTION
PASSWORD
Set whether or not to use the PIN CODE as the password
when connecting the MultiPresenter application to the pro-
jector.
• Not checked
Do not use the PIN CODE as the password.
• Checked
Use the PIN CODE as the password.
• By factory default, this is not
checked.
NOTE:
• If you change the setting of the operating mode, connecting to the MultiPresenter, it will not be reflected immediately. When the
MultiPresenter becomes unused condition, the change in the operating mode will be reflected.
7-6. NETWORK SERVICE
AMX setting
If you connect this device to a network compatible with the NetLinx control system of AMX Corporation, you can en-
able/ disable the detection setting from AMX Device Discovery. A check mark is not when the device is first shipped
from the factory.
See the website of AMX Corporation for more information on AMX Device Discovery.
HTTP server configuration
Set the password for logging into the PROJECTOR CONTROL screen. A maximum of up to 10
alphanumeric characters can be set for the password.
