Selecting power-saving in [STANDBY mODE]
The projector has two standby modes: [NORMAL] and [POWER-SAVING].
Power-saving mode is the mode that allows you to put the projector in the power-saving condition which consumes
less power than the Normal mode. The projector is preset for Normal mode at the factory.
NOTE:
• The HTTP server functions are not available during POWER-SAVING mode.
• The MONITOR OUT function is not available during POWER-SAVING mode.
• Control through the PC Control connector and LAN mode is not available during POWER-SAVING mode. For PC control and LAN
mode of the projector it is recommended to leave the projector in the Normal mode.
• When [PROGRAM TIMER] is turned on, the [STANDBY MODE] setting is ignored.
• Connecting the remote cable to the REMOTE jack on the terminal panel will forcibly select [NORMAL] for [STANDBY MODE]
during standby mode even though [POWER-SAVING] has been selected from the menu.
• Your setting will not be affected even when [RESET] is done from the menu.
NORMAL.........................Power.indicator:.Orange.light/Status.indicator:.Green.light
POWER-SAVING.............Power.indicator:.Orange.light/Status.indicator:.Off
Turning On or Off Remote Sensor [REmOTE SENSOR]
This option determines which remote sensor on the projector is enabled in wireless mode.
The options are: front/back, front, and back.
6. Using On-Screen Menu
