NEC NEAX2400 ICS, Руководство по программированию

Страница: 93 / 1089

NEAX2400 IPX Feature Programming Manual
Page 50
NDA-24297, Issue 1
A-59 Announcement Service - Attendant
A-59 Announcement Service - Attendant
General Description
This feature allows the Attendant, via the ATTENDANT CONSOLE [A-3], to hear a prearranged announcement
when the Attendant dials a predetermined access code.
Operating Procedure
1. Press an idle loop key.
2. Dial the announcement trunk access code.
3. Listen to the message from announcement machine.
Service Conditions
1. This feature requires one of the following hardware alternatives:
a.) Central Office Trunk (COT) or 2W E&M Trunk and announcement machine.
b.) Digital Announcement Trunk (DAT).
2. The following connections are available:
a.) multi-connection: several Attendants can connect to one announcement trunk at the same time.
b.) single connection: one Attendant can connect to one announcement trunk at a time.
3. This connection can be continuous until the Attendant presses the CANCEL key or can be discontinued
after 30 seconds. This function can be selected on a per-announcement trunk, and per-tenant basis.
4. Before connection to the announcement machine is made, the system can be programmed to return
ringback tone. This is selected on a per-tenant and per-announcement basis.
5. This service can be provided for a maximum of 127 announcements per-tenant, which includes the
announcement trunks for:
ANNOUNCEMENT SERVICE [A-15]
CALL FORWARDING - ALL CALLS - ANNOUNCEMENT [C-69]
CALL FORWARDING - INTERCEPT/ANNOUNCEMENT [C-25]
6. ANNOUNCEMENT SERVICE is provided to FCCS nodes that have no announcement trunk using the
trunk in the remote node.
Programming
STEP 1: ANPD
- Reserve a number level for trunk access. Assign for Connection Indexes Normal (N) and
Hooking (H). Assign for NND values in accordance with a predetermined numbering plan.
STEP 2: ASPA
- Assign an access code to the announcement trunk. Assign SRV = ANNC (Announcement
Service). The EQP number assignment should be as assigned in the AAED command. TYPE =? 0/1.
STEP 3: ARTD - Assign the announcement route as shown below. Be sure to provide privacy by programming
CDN 44:PRV as data “1”.
RT: 1
1-OSGS
:2 2-ONSG :3 5-TF :1 6-TCL :1 7-L/T :1
8-RLP :2 15-LSG :4
STEP 4: ARSC - Assign a Route Restriction Class (RSC) to the station that allows access to the Announcement
route. Assign RSC 0 to the Attendant, and allow that RSC access to the Announcement route.
STEP 5: ATRK
- Assign the LEN Number, Announcement Trunk Route Number. Assign one or more trunks to
a specific route used to connect to an announcement machine.