NEC NEAX2400 ICS, Руководство по программированию

Страница: 687 / 1089

NEAX2400 IPX Feature Programming Manual
Page 644
NDA-24297, Issue 1
S-3D Speed Calling - System - D
term
S-3D Speed Calling - System - D
term
General Description
This feature allows a D
term
user to call frequently dialed numbers using fewer digits (abbreviated call codes) than
would normally be required.
Operating Procedure
Originating a call from a D
term
1. Press the SPEED CALLING-SYSTEM (SPEED-SYS) key.
2. Dial the abbreviated call code (maximum of four digits). The LCD displays:
3. The call is completed.
4. If the D
term
does not have the SPEED-SYS key, dial the SPEED CALLING-SYSTEM access code, then
the abbreviated call code.
To operate from a SPEED CALLING-ONE TOUCH key
1. Press a FEATURE key, then a One Touch-Speed Calling key. The LCD displays previously stored digits.
2. Dial the SPEED CALLING-SYSTEM access code and the abbreviated call code.
3. Press the FEATURE key. The LCD displays:
4. To access, press the SPEED CALLING-ONE TOUCH D
term
[S-26D] key.
Service Conditions
1. SPEED CALLING-SYSTEM [S-3] codes programmed into system data are accessible to all stations with
a CLASS OF SERVICE-INDIVIDUAL [C-15] permitting speed calling.
2. Each abbreviated call code can store a maximum of 24 digits, including access codes and pauses.
3. The standard number of speed calling numbers stored in the NEAX2400 IPX is 1,000.
4. Speed calling numbers are programmed via system data from the MAINTENANCE ADMINISTRATION
TERMINAL (MAT) [M-18].
5. Stations may be denied access to SPEED CALLING - SYSTEM - D
term
via CLASS OF SERVICE-
INDIVIDUAL [C-15] assignment in system data. SPEED CALLING SYSTEM [S-3] may be allowed or
denied on either a station or tenant-wide basis.
6. TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may not
be applied to SPEED CALLING - SYSTEM - D
term
, depending on preference.
7. LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via SPEED CALLING-SYSTEM access.
8. When assigning the access code to the line/feature key, the abbreviated call code must be set at 2 to 4
digits.
(Time Display)
XXX
Abbreviated Call Code
SPEED SET
(Time Display)