NEC NEAX2400 ICS, Руководство по программированию

Страница: 655 / 1089

NEAX2400 IPX Feature Programming Manual
Page 612
NDA-24297, Issue 1
R-2 Remote Access to System
R-2 Remote Access to System
General Description
This feature allows a user outside the NEAX2400 IPX to access the system via an exchange network connection
without Attendant or station assistance. The outside user may originate calls over any or all of the PBX facilities,
such as WATS, FX, TIE Line or CCSA.
When a wrong code is received from a station/trunk, detailed information on the unauthorized user is output as
System Message [26-M] Toll Fraud Report.
Operating Procedure
To operate using AUTHORIZATION CODE [A-20]/FORCED ACCOUNT CODE [F-7]
1. Lift the handset; receive dial tone.
2. Dial the Remote Access number to connect to the NEAX2400 IPX; receive ringback tone through public
network.
3. If there is an announcement service, an announcement will be heard; receive dial tone.
4. Dial the AUTHORIZATION CODE/FORCED ACCOUNT CODE; receive PBX dial tone.
5. Dial the desired telephone number; hear ringback tone.
6. The called party answers.
To operate without using AUTHORIZATION CODE [A-20] / FORCED ACCOUNT CODE [F-7]
1. Lift the handset; receive dial tone.
2. Dial the Remote Access number to connect to the NEAX2400 IPX; receive ringback tone through the
public network.
3. Receive PBX dial tone.
4. Dial the desired telephone number; hear ringback tone.
5. The called party answers.
Service Conditions
1. When a call terminates from a TIE Line, this feature is available by dialing a specific telephone number.
2. After a call terminates to AUTOMATED ATTENDANT [A-82], AUTHORIZATION CODE [A-20] and
FORCED ACCOUNT CODE [F-7] services are available.
3. AUTHORIZATION CODE [A-20] is predetermined on a system basis. Refer to AUTHORIZATION
CODE
[A-20] for more information.
4. Announcement service is not provided when AUTHORIZATION CODE [A-20] service is not available.
5. Until the call is connected to an announcement trunk, ringback tone is heard.
6. Announcement trunks are to be used for single connections only. Announcement service is not available
when the announcement trunks are all busy or are not provided. (The caller receives PBX dial tone.)
7. When a call terminates to the called station, the following services are available:
CALL FORWARDING - ALL CALLS [C-5]
CALL FORWARDING - BUSY LINE [C-2]
UCD [U-1]
CALL WAITING
8. The second announcement is not provided to the ISDN trunk.
9. The announcement is provided for a maximum of 30 seconds. Therefore, the message recording should be
completed within 30 seconds.