E-14
2.1.
Bracket Replacement
Depending on the type of system, installation of this product requires either a standard bracket or a low-profile
bracket. NEC provides both of these brackets with the product. By default Full Height bracket is attached. Please
replace the bracket according to the following steps as necessary.
1.
Remove screw on this product with a screw driver.
2.
Remove the attached bracket and install the other bracket. Please keep the removed bracket.
3.
Attach the bracket with the bracket fixing screw.
Memo.
When attaching / detaching the bracket, move the bracket in the direction shown in the following figure.
N8104-178
Detach
Attach
N8104-179
Detach
Attach
N8104-180/181
Detach Attach
Bracket
LAN port
1
As shown in the figure on the left side of the figure below,
Rotate the bracket toward the arrow and remove it.
Bracket
LAN Port
Align the "raised dot" on the LAN port to the "hole" on the bracket.
1
Rotate the bracket toward the arrow and attach it.
2
Hole
Raised
dot
Содержание N8104-178
