17
Install the Drivers
1.
Put on the NIC to the server.
2.
Boot up the system.
Click [
Cancel
] to [
Found New Hardware Wizard
] after login the system.
3.
Check whether the adapter is recognized by the following method.
(1) Open [
Control Panel
].
(2) Open [
Administrative Tools
] -> [
Computer Management
] -> [
Device Manager
].
(3) Make sure [
Ethernet Controller
] is appear in [
Other devices
] tree.
4.
Installing driver
i)
Insert the Driver Disk in the CD drive.
ii) Open
[
Device Manager
] and double click [
Ethernet Controller
].
iii) Click
[
Driver]
tab and click [
Update Driver
].
iv) Select
[
No, not this time
] to [
Hardware Update Wizard
] and click [
Next
].
v) Select
[
Install from a list or specific location (Advanced)
] and click [
Next
]
vi) Select
[
Include this location in the search
] and click [
Browse
] to specify the following folder
[
<CD Drive letter>:¥CHELSIO
]
Click [
Next
].
vii) The driver's installation will start after appropriateness module searching complete.
* By some condition [
Hardware Installation
] dialog will appear.
Click [
Continue Anyway
]
viii) [
Found New Hardware Wizard
] will appear. Click [
Cancel
].
ix) Click
[
Finish
] to [
Hardware Update Wizard
].
x)
[
Chelsio S310 10G Ethernet Function Enumerator
] will appear in [
Multifunction adapters
]
after installation complete.
xi) [
!?Chelsio Network device
] properties will appear under [
Other device
s] tree. Right click to
open the [
properties
].
xii) Repeat iii) to vii) to install this device driver.
xiii) Click [
Finish
] to [
Hardware Update Wizard
]
5.
Reboot the system.
