English-17
English
HUMAN SENSING (Option sensor only)
The sensor detects the movement of a person by using the HUMAN SENSING function. The HUMAN SENSING has
three settings:
OFF:
No human sensing.
1 (LIGHT):
After it is detected that there is no person after a period of time, the monitor shifts to low brightness mode
automatically to reduce the power consumption. When a person comes near the monitor again, the monitor will
automatically return to normal mode. START TIME adjusts the wait time to react.
2 (DEEP):
After it is detected that there is no person, the monitor shifts to power saving mode automatically to reduce
the power consumption. When a person comes near the monitor again, it resumes from the power saving mode.
START TIME (HUMAN SENSING) (Option sensor only)
Adjusts the wait time of entering to low brightness mode or power saving mode when Human Sensor detects no
person.
DV MODE
Dynamic Visual Mode allows you to select from the following settings:
STANDARD:
Standard setting.
TEXT:
Setting that makes letters and lines crisp; best suited for basic word processing and spreadsheets.
MOVIE:
Setting that boosts dark tones; best suited for movies.
GAMING:
Setting that boosts whole tones; best suited for games that use vivid, colorful images.
PHOTO:
Setting that optimizes contrast; best suited for still images.
DYNAMIC:
Setting that adjusts the brightness by detecting the screen’s black areas and optimizes it.
NOTE:
This function is disabled when Color Control System is set to L/B, PROGRAMMABLE or DICOM SIM.
STANDARD is used for TCO Certificate compliance.
SCREEN
AUTO ADJUST (Analog input only)
Automatically adjusts the image position, H. Size and Fine settings.
AUTO CONTRAST (Analog input only)
Adjusts the image displayed for non-standard video inputs.
LEFT / RIGHT
Controls horizontal image position within the display area of the LCD.
DOWN / UP
Controls vertical image position within the display area of the LCD.
H.SIZE (Analog input only)
Adjusts the horizontal size by increasing or decreasing this setting.
If the “AUTO Adjust” function does not give you a satisfactory picture setting, a further tuning can be performed by
using the “H.SIZE” function (dot clock). For this a Moiré test pattern could be used. This function may alter the width
of the picture. Use LEFT/RIGHT key to center the image on the screen. If the H.SIZE is wrongly calibrated, the result
would look like the left drawing. The image should be homogeneous.
When H.SIZE value is
wrong.
When H.SIZE value is
improved.
When H.SIZE value is
correct.
