NEC Dterm DTL-RPT-2, Руководство пользователя

Страница: 19 / 30

D
term
Cordless DECT Issue 1.0
DTL-RPT-2 Cordless DECT Repeater Guide 2 - 7
___________________________________________________________________________________
___________________________________________________________________________________
3. Insert the AC adapter connector into the yellow adapter opening. Thread the
cord according to the illustration.
4. Carefully replace the cover, and press until you hear it click. Do not angle it as
you replace it.
5. Use the AC adapter to connect the repeater to a standard 120 V AC outlet. (Do
not use an outlet controlled by a wall switch!) The LED on the repeater flashes
briefly, then remains on and steady.
S
ECTION
6 A
CTIVATE
R
EGISTRATION
M
ODE ON
B
ASE
You need to activate registration mode on your base before you can register your
repeater to it. Refer to the Owner’s Manual for your base unit for registration
instructions.

You only have to activate registration on the base once, regardless of how many repeaters
you want to register (up to 6).
6.1 Register Repeater to Base
You can register up to six repeaters to each base. Repeat these steps as
needed for each repeater. The repeater seeks out the base with strongest
DECT/GAP signal and automatically registers to that base. Make sure no
other bases in range are in registration mode. If more than one base is in
registration mode at the same time, you cannot control which base the
repeaters register to.
Figure 2-7 Threading the AC Adapter Cord