English-7
English
Attaching Mounting Accessories
The monitor is designed for use with the VESA mounting
system.
1. Attach Mounting Accessories
Be careful to avoid tipping the monitor when attaching
accessories.
VESA Mounting Interface (M6)
300 mm
300 mm
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the front face,
place the protective sheet on the table underneath the LCD
monitor. The protective sheet was wrapped around the LCD
monitor in the original packaging. Make sure there is nothing
on the table that can damage the monitor.
When using mounting accessories other than NEC compliant
and approved, they must comply with the VESA Flat Display
Mounting Interface Standard (FDMI).
NOTE:
Prior to installation, be sure to place the monitor
on a flat area with adequate space.
2. Installing and removing the optional
table top stand
CAUTION:
Installing and removing the stand must be done
by two or more people.
For installation, follow the instructions included with the
stand or mounting equipment. Use only those devices
recommended by the manufacturer.
NOTE:
ONLY use screws which are supplied with the
optional table top stand.
When installing, do not put your hands on the
monitor or apply force. The monitor may become
distorted.
When installing the LCD monitor stand, handle the unit with
care to avoid pinching your fingers.
NOTE:
Use the ST-401. Please refer to the ST-401
user’s manual for more detail.
Height adjustment
1. The lines on the stand pole are indicators of the height
adjustment. Please adjust the pipe to the lines.
C551 High/Low
C501
C431
Pipe
Adjust the pipe to a line.
Stand pole
2. Please install the stand pole and the pipe with included
screws. Please screw the two screw holes at the pipe.
Pipe
Stand pole
NOTE:
Installing the monitor at the wrong height can
cause tipping.
Please install your monitor at proper height.
3. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the enclosure
to allow heat to disperse, as shown below.
100 mm
100 mm
100 mm
100 mm
30 mm
Must be under 40 Degree Celsius.
Allow adequate ventilation or provide air conditioning around
the monitor, so that heat can properly dissipate away from
the unit and the mounting equipment; especially when you
use monitors in a multiple screen configuration.
NOTE:
The sound quality of the internal speakers will be
different depending on the acoustics of the room.
