English-12
1. Determine the installation location
CAUTION:
Installing your LCD monitor must be done by a
qualified technician. Contact your supplier for
more information.
CAUTION:
MOVING OR INSTALLING THE LCD MONITOR
MUST BE DONE BY TWO OR MORE PEOPLE.
Failure to follow this caution may result in injury if
the LCD monitor falls.
CAUTION:
Do not mount or operate the monitor upside
down.
CAUTION:
This LCD monitor has internal temperature
sensors.
If the LCD monitor becomes overheated, a
“Caution” warning will appear. If the “Caution”
warning appears, stop using the unit and allow it
to cool.
If the LCD monitor is used in an enclosed area
or if the LCD panel is covered with a protective
screen, please check the inside temperature of
the monitor by using the “HEAT STATUS” control
in the OSD (see page 32).
IMPORTANT:
To avoid scratching the LCD panel, always
place a soft cloth, such as a blanket that is
larger than the monitor’s screen area, on the
table before laying the monitor face down.
2. Install the remote control batteries
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
A. Press and slide to open the cover.
B. Align the batteries according to the (+) and (–) indications
inside the case.
C. Replace the cover.
CAUTION:
Incorrect usage of batteries can result in leaks or
bursting.
NEC recommends the following battery use:
• Place “AAA” size batteries matching the (+) and (-) signs
on each battery to the (+) and (-) signs of the battery
compartment.
• Do not mix battery brands.
• Do not combine new and old batteries. This can shorten
battery life or cause liquid leakage of batteries.
• Remove dead batteries immediately to prevent battery
acid from leaking into the battery compartment.
• Do not touch exposed battery acid, it may injure your skin.
NOTE:
If you do not intend to use the Remote Control for
a long period of time, remove the batteries.
3. Connect external equipment
(See page 14 and page 15)
• To protect the external equipment, turn off the main power
before making connections.
• Refer to
the user’s manual of your equipment for further
information.
NOTE:
Do not connect/disconnect cables when turning
on the monitor or other external equipment, as this
may result in a loss of the monitor image.
4. Connect the supplied power cord
• The equipment should be installed close to an easily
accessible power outlet.
• Please fasten the power cord to the LCD monitor by
attaching the screw and clamp. (Recommended Fasten
Force: 139 - 189N•cm).
• Fully insert the prongs into the power outlet socket.
A loose connection may cause image degradation.
NOTE:
Please refer to the “Important Information” section
of this user’s manual for proper selection of an AC
power cord.
Screw
Clamp
5. Cable information
CAUTION:
Use the attached specified cables with this
color monitor so as not to interfere with radio
and television reception.
For mini D-Sub 15-pin, please use a shielded
signal cable with ferrite core.
For HDMI, DisplayPort, USB and D-Sub
9-pin, please use a shielded signal cable.
Use of other cables and adapters may
cause interference with radio and television
reception.
6. Switch on the power of all the attached
external equipment
When connected with a computer, switch on the power of the
computer first.
7. Operate the attached external equipment
Show the signal on the screen from the desired input source.
Setup
