78K0R – Save It!
11. IAR Embedded Workbench 78K0R – Save It! sample project
The IAR Embedded Workbench IDE is a very powerful Integrated Development Environment that allows you
to develop and manage a complete embedded application project.
The now described project can be found on the
78K0R – Save It!
CR-ROM in the
“\samples\TK-
78K0RKE3L startup sample”
folder.
To run/debug the project with the IAR C-SPY debugger it is necessary to follow the steps described below in
this chapter.
For further information about the IAR Embedded Workbench ant the included functionalities please refer to
the regarding User’s manuals available on the
– Save It!
CR-ROM in the
“\IAR Systems\doc”
folder.
Note: Make sure that the Flash memory is erased properly before first download the project to the
target device. Refer to the chapter
Erasing the flash memory (using the WriteEZ4)
.
11.1 Hardware setup
To run the program it is necessary to set up the TK-78K0RKE3L board in the following way.
Switch / Jumper
Mode position
SW1 Debug
SW2 EXT
SW3.1 – SW3.3
ON
SW3.4 – SW3.8
Any
JP1 Short
JP2 1-3
shorted
Table 10: IAR EWB 78K0R – Save It! sample project hardware setup
11.2 Loading the Save It! sample project
After starting the IAR Embedded Workbench for 78K the Startup window pops up. In this window you are
able to choose the
Open existing workspace
button.
Figure 32: IAR Embedded Workbench Startup window
_______________________________________________________________________________________________
User’s Manual
U19663EE1V0UM00
36
