5
Continued on next page
V
o
ice/Videophone Calls
●
If a videophone call is not connected
When a videophone call is not connected, the cause
of the failure appears.
z
The cause may not appear depending on the
situation.
z
Depending on the type of the other party’s phone or
network service subscription, the reason may not
accurately reflect the other party’s actual status.
z
If the videophone call is not supported, your call is
automatically switched to a voice call when you set
“Auto redial as voice” to “ON”. However, the
videophone may not work properly if you call an
ISDN synchronous 64K access point, 3G-324M-
incompatible ISDN videophone (as of October,
2008) or if you dial a wrong number. Call charges
may apply.
Switching a Voice/Videophone
Call during a Call
z
You can use this function with terminals compatible
with voice call/videophone call switch.
z
You can switch calls only when you are the caller.
z
To switch calls, the receiver needs to set “Ntfy
switch-mode” beforehand.
<Example: To switch a voice call to a videophone
call>
1
In-call screen (p.2)
X
d
(V.phone)
X
“YES”
During switching, a screen appears indicating
that the calls are being switched, and voice
announcement is played.
■
To switch a videophone call to a voice call
X
Videophone in-call screen (p.2)
X
u
(FUNC)
X
“Change to voice”
Display
Cause
Check number then
redial
The dialed phone number is not
in use
Busy
The line is busy
• This message may also appear
during packet communication,
depending on the other party’s
terminal.
Busy with packet
transmission
The other party is using packet
communication
Out of service area/
power off
The other party is out of service
area or the phone is turned off
Your call is being
forwarded
The call is being forwarded (a
videophone call is made when
the forwarding number is for a
3G-324M-compatible
videophone)
Redial using voice
call
The forwarding phone is not
compatible with videophone
Please activate
caller ID before
dialing again
The other party has set the
Caller ID request service
This number is not
available
The other party has set the
Nuisance call blocking service
Upper limit has
been exceeded
Connection failed
The upper limit set for a Limit
billing plan (Type Limit or Family
Wide Limit) is exceeded
Connection failed
You attempted to connect
without notifying your caller ID
(when dialing into visualnet, etc.)
• This message may also appear
in other situations.
Set Caller ID Notification to “ON”
and retry.
Please make your
call from the i-mode
web page
You attempted to make a
videophone call to watch V-live
without browsing the i-mode
official site
N
z
It takes about 5 seconds to switch the calls. Note
that the signal quality may affect the switching
time.
z
You cannot switch calls in the following cases:
• When the other party is holding the call
• When the other party activates Record
message
z
The displayed call duration is reset to 0 second
each time the calls are switched. However, the
total time of the voice and videophone calls is
displayed after the call ends.
Digital communications
charges apply after this
screen appears.
