09
INSTALLATION AND ADJUSTMENT
WARNING:
● To avoid any danger, after you have installed the wheel, please test the brake system before cycling.
● Avoid touching the brake discs/rotors with your hand to prevent oils from your hands on the surface. If you have to clean
it, use suitable brake cleaner.
● If the quick release lever is not completely closed, it may fully open again easily. This can cause the wheel to fall off the
bike, leading to serious falls and bike damage. To ensure that your wheel is securely in place, the quick release lever
should offer considerable resistance when closing by hand and must always be fully closed before riding.
3.3 Handlebar and Stem Assembly
1. Open the top cover, align the stem with the head tube and slide it on. Tighten the screw at the top of the stem.
Tools you may need: 5mm Allen wrench.
2. Align the handlebar to be perpendicular to the wheel, then insert and tighten the two side-facing screws as shown
below. Tools you may need: 4mm Allen wrench.
3. Move the handlebar up or down to adjust to the desired angle, then tighten the rear-facing screw at the top of the stem
to lock the handlebar in place. Tools you may need: 5mm Allen wrench.
4. Close the cover to complete installation and adjustment.
4mm
3
4
1
2
5mm
Screw for adjusting the
handlebar position
5mm
