The UTP cab bus panel provides a low cost means of adding
walk around capability to your layout.
A front panel plate and two #6 screws for attaching it to the UTP
printed circuit board are supplied. Note that if you want the LED
at the top of the panel you should install the UTP “upside
down”. This will also keep dust from building on (and inside)
the RJ-12 connectors
The panel has 4 RJ-12 connectors wired in parallel, two on the
front and two on the rear. Your cab bus can be “daisy chained”
from one panel to the next using the rear connectors. One or
two cabs can then be plugged in to the front connectors.
Please
note the “Command Station” side versus the “More UTP
panels” side in the figure below
when wiring your panels.
COMMAND
STATION
MORE UTP
PANELS
Cab Bus Fascia Panel
Model # UTP
NCE Corporation
82 E Main Street
Webster, NY 14580
Warning: This product contains chemicals known
to the State of California to cause cancer, birth
defects, or other reproductive harm
