NCD Explora 450 Series, Инструкция по установке

Страница: 51 / 62

Installing Additional Memory
Installing Optional Equipment in the Monitor Support Base 6-11
Testing Memory
The
NC
must be installed before you can run the memory test. After
installation, you can access the Boot Monitor to run the memory test.
Accessing the Boot Monitor
1. Turn on the system or reboot (if the system is already on).
2. After the Boot Monitor title and version number, messages similar to the
following appear. Press the Escape key to interrupt the booting process.
Searching for IP address...
Using IP address IP address of terminal
Searching for subnet mask
Using subnet mask subnet mask
...........................
(Press Escape to interrupt booting.)
>
Memory Test
Run the memory test as follows:
1. Type a question mark and press the Return key to find the command for
Extended Tests.
> ? <CR>
2. Type the Extended Tests command and press the Return key.
> EX <CR>
3. Type the number associated with the Test Available Memory test and press
the Return key.
Enter test number ? Test-number <CR>
4. Press the Return key to run the test once.
F Loop forever
E Loop until error
Q Main menu
<cr> Test once
Esc Abort testing
Enter choice? <CR>
If memory is good, a diagnostic code such as the following displays:
Pass -00000001