Version 22.12.2022
HW CAM (V31)(V64)
RL1-GVIF
P
a
g
e
14
2.5.1.
After-market rear-view camera
For activating the rear-view camera when reverse gear is engaged, an external switching
signal from the reverse gear light is required.
As the reverse gear light’s power supply isn’t
voltage-stable all the time, an ordinary open relay (e.g AC-RW-1230 with wiring AC-RS5) or
filter (e.g. AC-PNF-RVC) is required. The diagram below shows the connection type of the
relay.
Connect the green
switching input cable
to the output connector (87) of the relay.
Connect the Reverse light’s power
-cable to coil (85)
and the vehicle’s ground to coil
(86) of the relay.
Connect the output connector (87) of the relay to the rear-
view camera’s power
-
cable, like you did it to the green
switching input cable
before.
Connect stabile and per12V to the relay’s input connector (30).
Note:
Don’t forget to set the
Dip 5 to ON.
In Jaguar and Land Rover vehicles the automatic switching to an after-market rear-view
camera is only possible in navigation mode.
